DAA Colour Inlay for Alpha-Xi Pistol Mag Pouch

Description

The DAA Alpha-Xi Pouch Inlays is designed to fit precisely into all the pockets of the Alpha-Xi pouch body.

These inlays come with 3M adhesive tape for secure installation. Before adhering, ensure each piece fits correctly, as each pocket requires a specific inlay. Avoid placing an inlay in the pocket intended for the Ball Joint attachment.

Each inlay has a protective film on the front and an adhesive cover on the back, both of which should be peeled off before installation.

Installation Steps:

1. Carefully break the inlays out of their frame, using your hands to break the small bridges holding them in place.
2. If desired, use a knife to clean off any tails left by the bridges, although these won’t be visible once installed.
3. Check that you have the correct inlay for the pocket you’re addressing.
4. Peel off the transparent film from the front and the 3M adhesive cover from the back.
5. Position each inlay into its correct pocket in the pouch body and fit it in place.

Removal Instructions:

To remove the inlays after installation, first, take out all plastic spacers to access the small holes drilled through the pouch body. Using a sharp tool, like a small hex key, gently push from the inside of the inlay until it loosens at the corner. Carefully work it out of its pocket, keeping in mind that the inlay may break during removal.